Page 1 of 1
madrix how to work with apa102 led
Posted: Wed Nov 12, 2014 12:38 pm
by MALLED
Recently,I have some
APA102 LED samples,I have the datasheet of the LED,but I don't have any suitable control system for them, anyone tried them?how to work with the madrix controller?
Re: madrix how to work with apa102 led
Posted: Wed Nov 12, 2014 5:05 pm
by Guertler
Hello MALLED,
Welcome to the MADRIX forum.
.
To control an APA 102 LED fixture you will need an interface which converts the data which will be send with MADRIX to the APA 102 protocol.
MADRIX can send the data via Art-Net, DMX, sACN, KiNET and Insta/ROBE protocols.
Re: madrix how to work with apa102 led
Posted: Mon Sep 26, 2016 2:34 pm
by ufuk_ari_can
heyy dear
how can i control apa102 with nebula?
and how much pixel(or address) control one port of nebula?
Re: madrix how to work with apa102 led
Posted: Tue Sep 27, 2016 7:58 am
by Wissmann
as you can see here
http://www.madrix.com/en/home/products/nebula.html
MADRIX NEBULA is able to control apa102 and supports up to 680 RGB Pixel on each port .
Re: madrix how to work with apa102 led
Posted: Tue Sep 27, 2016 8:39 am
by ufuk_ari_can
<ohh thanks... pixels ok.
i wanna ask how to set apa in madrix.
how i set apa leds when make fixture?
Re: madrix how to work with apa102 led
Posted: Tue Sep 27, 2016 8:43 am
by Wissmann