Help making a patch for a partial LED strip?
Posted: Wed Mar 15, 2017 3:08 pm
Hello,
I'm trying to map a cube of LED strips with only the corners of the cube lit by LEDs. I have it set up as 12 LED strips, 1 universe each for 12 universes. Each LED is set up on the physically on the cube such that a few of the lights before and after the edge they're applied to need to be turned off and be invisible to the patch. The problem I've run into is when I remove those extra lights on either ends of the strip they bump all the other universes arrangements down so that they're not fitting the cube properly. Is there any way I can lock the other universes assignments/location while also disabling a few extra lights on the ends of the other lines/universes? Thanks for the help!
I'm trying to map a cube of LED strips with only the corners of the cube lit by LEDs. I have it set up as 12 LED strips, 1 universe each for 12 universes. Each LED is set up on the physically on the cube such that a few of the lights before and after the edge they're applied to need to be turned off and be invisible to the patch. The problem I've run into is when I remove those extra lights on either ends of the strip they bump all the other universes arrangements down so that they're not fitting the cube properly. Is there any way I can lock the other universes assignments/location while also disabling a few extra lights on the ends of the other lines/universes? Thanks for the help!