MADRIX Forum

Hi, i just want to know if I can control the Wahlberg winch with our madrix software? The dmx chart of winch is channel 1, to be the position rough its says that multiplied by 16bit channel,
Channel 2 is, position fine
Channel 3,is speed
Channel 4, is used to run the motor between 50 to 55%, of 255
Channel 5, for manual up
And 6 for manual down, is there any idea how can I work with this winch, thanks a lots

Hi Siakra,

Here you can learn how to control kinetic systems with MADRIX:
http://help.madrix.com/tutorials/html/h ... with_.html
http://help.madrix.com/tutorials/html/h ... xture.html

I already created a corresponding fixture and sent it to you by e-mail.