Page 1 of 1
Use of Enttec DMX USB Pro as input device
Posted: Mon Dec 12, 2011 8:54 pm
by jbrown2000
I'm trying to configure my Enttec DMX Pro for remote control of Madrix. When I scan under Device Manager/DMX devices, it is recognized, but comes up as an output device under Settings and won't let me change it to an input device. I do have it selected under Devices (USB/PCI) in preferences. And the Enttec box works under other software (LightFactory) so I know the box is good.
Any help greatly appreciated.
Jeff Brown
Re: Use of Enttec DMX USB Pro as input device
Posted: Tue Dec 13, 2011 9:23 am
by Wissmann
Hi,
you are sure you enabled the DMX USB Pro in the Preferences?
Because it sounds like MADRIX does not recognize your interface as a DMX USB Pro, maybe it is about the Open DMX USB and with this MADRIX did not give you the option as a input interface.
Re: Use of Enttec DMX USB Pro as input device
Posted: Fri Oct 18, 2013 7:19 am
by Jorgematto
I am having the same issue. It is recognized it sees usbpro but it does not allow me to change it to input. It's sees it in madrix 2 and let's me change.
Re: Use of Enttec DMX USB Pro as input device
Posted: Fri Oct 18, 2013 7:29 am
by Wissmann
Hi Jorgematto,
.
because of continues issues with this kind of interface we decide to disable the input option for this interface in MADRIX 3.