MADRIX Forum

I have a mixture of WS2811 12V nodes and WS2812 12V strips. The HinksPix controller can run both strings in test mode, but Madrix will only output to the WS2811 12V nodes, with the strips totally dark. I've been using Madrix for 10 years and have an ultimate license, so it is not a firewall or netwo...

Thanks so much ! I discovered that the "Alienware Sound Center" App that boots on startup was the culprit. I deleted it, and now Madrix works perfectly!
Thanks again !

I've tried fixing registry errors, tried uninstalling and reinstalling the Realtek audio drivers, still no luck. I've got it on Realtek stereo mix PRIMARY for S2L and M2L Effects. If I switch to ASIO, I get no audio errors, but still no audio output on Madrix. I'm going to try disabling the ASIO, bu...

That worked thanks

Hi- I'm running Madrix on a new Alienware laptop and for the life of me I can not seem to get the audio working. I got it working on the previous laptop but now I'm getting the error : WASAPI: CaptureStart:Initialize() failed! Error 0x88890008: Unknown error 0x88890008. Can't start capturethread. I'...

Hi- I have an array that is 192 X 12 pixels. The way that my controller board addresses the array is one DMX universe = 150 pixels or 450 DMX channels. When I set up the patch editor for the array at 192 X 12, Madrix automatically sets the channels at 512, which means the virtual addressing and the ...

Thanks for the reply. Most programs like Beyond 3.0 will send out a DMX message to trigger Madrix. You just have to figure out who is the master program and who is the slave.

Hi- In the Light o Rama software, I'm able to execute a windows 10 shell command at the beginning of the sequence to start a cue in the Beyond 3.0 laser software that I have running concurrently. Is it possible to execute a similar command script in Madrix? I need to synchronize the programs to prev...