Madrix doesn't see output controllers

[urthegman]

Hello All, I have four enttec clone controllers which worked like a charm last year AND at the end of July. They are attached with usb cables to a powered hub. Madrix now only recognizes the input controller but not the three output controllers? Don't know what could have happened in a little over two months? The controllers are seen by the computer and I have updated the drivers but madrix still does not see the controllers. Any ideas???? Thanks, George

[Wissmann]

What kind of controllers you are exactly want to use?

[urthegman]

They are entecc pro clones.

[urthegman]

Issue is resolved, I had a bad 7 port hub that I replaced and all is now working.

[Albert07]

Thanks for the reply! Im able to see the device inside of Madrix in shows both a in and output but im not able to "configure" the device inside of Madrix... I was hoping it would work but its not a big deal... I think i will be picking up a Plexus or Neo


_________________
Try out our free six sigma certification and latest comptia coloradotech.edu training courses to get high flying success in final and fmuniv.edu exams