Version 2.9 Kinet
Moderator: MADRIX Team
Version 2.9 Kinet
Hi,
I've just installed the 2.9 version, but was having a strange issue. Only the first port on my PDS-480 PSUs would display any data.
All 16 ports show up in device manager, but only the first port on each device works. (they're patched to universe 1 and universe 17).
I've downgraded to 2.8a and it works and tried upgrading to 2.9 again and the same thing happens. I've tried reloading older setups and creating a new setup from scratch and still no luck.
Currently I've downgraded to 2.8a again.
Thanks, let me know if there's any additional info I can give you.
Nathan
I've just installed the 2.9 version, but was having a strange issue. Only the first port on my PDS-480 PSUs would display any data.
All 16 ports show up in device manager, but only the first port on each device works. (they're patched to universe 1 and universe 17).
I've downgraded to 2.8a and it works and tried upgrading to 2.9 again and the same thing happens. I've tried reloading older setups and creating a new setup from scratch and still no luck.
Currently I've downgraded to 2.8a again.
Thanks, let me know if there's any additional info I can give you.
Nathan
Re: Version 2.9 Kinet
Dear Nathan,
.
thanl you very much for this report.
We check this out immediately.
.
thanl you very much for this report.
We check this out immediately.
LEDs are nothing without control 
Re: Version 2.9 Kinet
Since yesterday the bug should be fixed. Just redownload the Installer please.
LEDs are nothing without control